Add Mitee-Bite VersaGrips to your shops’ workholding arsenal. The VersaGrip™ system compliments your use of TalonGrips by enabling you to securely hold odd shaped parts while machining at the same speeds and feeds you are used to with TalonGrips. If you aren’t using TalonGrips for first op work yet… go take a look on the Mitee-Bite TalonGrips page.
The VersaGrip system can accommodate a wide range of part sizes as well as holding multiple parts in a single cycle. Manufactured from A2 Steel, the hardened (51-53 RC) VersaGrip™ has penetrating teeth designed to bite into your workpiece preventing lateral and horizontal movement. VersaGrips will hold onto castings, flame cut components, even parts with a negative draft!
Some users have even used them for short parts on lathes!
|Use Mitee-Bite VersaGrips to hold onto irregular shaped parts..||large round parts….||or vertically on Tombstones!|
A = 19.05mm, B = 9.52mm, C = M5
Recommended gripping height is between 1.5 & 3.5mm